HOWTO: Belkin wireless g usb network adapter F5D7050
(Removed reference to an article that no longer exists on the Web. Tidied up a bit. Changed to follow SL Wiki editing guidelines.)
Latest revision as of 01:10, 22 September 2011
Thought I would offer this brief 'how to' on setting this device up. It comes with a USB Wireless G stick and also a base station that you could use to move the USB stick around. The cable on the base is about 8 - 10 feet long. The stick works with or without the base.
This device is a relatively cheap USB Wireless G pen/stick - you can get them for circa US$40 and mine has a great signal strength sitting 6 rooms away (about 200 feet) from an access point. You can get one from an on-line store even (e.g. http://www.nextdaypc.com/main/products/details.aspx?pid=1912738&rsmainid=ND0011694&).
It can use 2 different modules depending on the FCC ID:
K7SF5D7050A - rt2500 K7SF5D7050B - rt73
The modules are in Portage. However, I couldn't get it to work with the ones included on the Sabayon Linux 3.2 LiveDVD, and lsmod would actually show both the rt2500 and rt73 modules loaded. I tried for about 3 hours to get it to work with the one for my card, which uses the rt73 module.
The modules are also available at http://rt2x00.serialmonkey.com
This brief howto covers the rt73 setup.
Download the daily cvs from the above address - rt73-cvs-daily.tar.gz
$ tar xzfvp rt73-cvs-daily.tar.gz
Remove the ones that are in Portage:
# emerge -C rt2500 # emerge -C rt73 # emerge -C rt73-firmware
Remove the leftover modules in your kernel modules directory. Since I am still running 2.6.18-gentoo-4, mine are at:
# rm /lib/modules/2.6.18-gentoo-r4/net/rt2500.ko # rm /lib/modules/2.6.18-gentoo-r4/net/rt73.ko
Change to the directory you extracted the daily cvs:
# cd rt73*/Module
Make and make install:
# make && make install
Edit the file /etc/modules.d/rt73 and change it to:
#alias usbra? rt73 alias ra0 rt73
Run modules-update force:
# modules-update force
Load the module:
# modprobe rt73
Now, run the command iwconfig and it should show something about rausb0 but it wont have an IP address yet.
create the net.rausb0 by linking it to net.eth0 in the init.d directory:
# /etc/init.d/net.rausb0 start
And use default settings. If you need to set ESSID or Encryption, you will need to modify /etc/conf.d/wireless
When done, you should be able to run iwconfig and show your connected settings:
# iwconfig lo no wireless extensions. eth0 no wireless extensions. vmnet1 no wireless extensions. vmnet8 no wireless extensions. rausb0 RT73 WLAN ESSID:"tSp" Mode:Managed Frequency=2.462 GHz Access Point: 00:06:25:A5:A4:F5 Bit Rate=11 Mb/s RTS thr:off Fragment thr=65534 B Encryption key:off Link Quality=77/100 Signal level:-62 dBm Noise level:-99 dBm Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0